Car Design Evaluation Our proposed solution for our F1 car was to:- Be designed using Solidworks software. Be finished using a limited amount of hand finishing. Be made from a single balsa blank. Be modelled in 3D and machined on a CNC router. Be complete with a high quality finish. Fit the dimensions as outlined in the rules and regulations. Be decorated with the appropriate colour scheme Our evaluation for our F1 car is that it:- Was designed using Solidworks software. Was finished using a limited amount of hand finishing- solely sanded with various grades of sandpaper. Was made from a single balsa blank. Was modelled in 3D and machined on a CNC router. Is complete with a high quality finish- primed numerous times then finished with 3 coats of spray paint. Fits the dimensions as outlined in the rules and regulations. Is decorated with the appropriate colour scheme. Specification Our proposed solution was to :- Be designed using Solidworks software. Be finished using a limited amount of hand finishing. Be made from a single balsa blank. Be modelled in 3D and machined on a CNC router. Be complete with a high quality finish. Fit the dimensions as outlined in the rules and regulations. Be decorated with the appropriate colour scheme. Design Process Figure 1: Starting block. Figure 2: First cut. Figure 3: Taking shape. Figure 4: Rear airfoil design. Figure 5: Front airfoil design. Figure 6: Taking final shape. Final Car Figure 7: The final design. Figure 8: On the road!